Hendi 273845 Gebrauchsanweisung Seite 5

Main parts of the appliance
1. Internal wires of power cord: Connection with
the electrical wires from the power system
2. Hooking hole: Hanging the lamp to the ceiling
3. Rotating knob: Adjusting the power cord length
Preparations before first use
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages, DO
NOT use the appliance. Please contact supplier
(See ==> Warranty).
• Clean the appliance before use (See ==> Cleaning
and Maintenance).
Preparation before installation
CAUTION: Before installation, check the appliance
to make sure there is no damage. CLOSE the elec-
trical power circuit system & switch OFF the appli-
ance before starting installation work.
Attention! Installation work should be carried out
by qualified electrician. Contact your local authority
for advice if have question. DO NOT attempt to in-
stall, repair and maintenance by yourself.
• Verify prior to installation that the ceiling can
safely support the appliance.
• Make sure that no electrical wires, water pipes,
gas pipes or other lines are located around the
installation location.
4. Cap cover: Fix the length of the power cord after
setting
5. ON (I) / OFF (0) switch: Switch ON / OFF the lamp
6. Lamp shade: Control the direction of the light
• Make sure the appliance is completely dry.
• Multiple installations of the lamps must have a
minimum distance of 40 cm between centre of
the shade of each unit.
• Keep a minimum of 30 cm distance from the
walls and other flammable or colour-sensitive
objects.
• Consult a qualified contractor for assistance
about the structure of the ceiling. This is to en-
sure that the installation is carried out properly
and safely.
• Switch OFF the appliance by pressing the switch
(5) on the appliance at the "0" position.
Attention: Before starting the installation, make
sure you have all the tools such as screwdriver,
electric drills, measuring tape, marking pencil,
wall anchors, wiring nuts, mounting bracket with
hook, etc. (All are not supplied) and make sure they
are well functioning.
EN
5