HELIX DSP.3 Handbuch Seite 21

The general DSP settings should be con-
ducted with the DSP PC-Tool software be-
time.
mation about connecting the DSP.3 to a com-
puter can be found below.
Connection to a PC
with our DSP PC-Tool software.
The user interface is designed for easy handling of
each of the eight DSP channels. Prior to connect-
site and download the latest version of the DSP
PC-Tool software.
Check from time to time for software updates. You
al on
We strongly recommend to carefully read the user
manual (Sound Tuning Magazine) before using the
plications and failures.
Important: Make sure that the signal processor is
not connected to your computer before the software
In the following the most important steps how to
1.
your computer.
9. Connecting the remote output
This output (Remote out) is used to supply re-
use this remote output signal to turn on the
noises.
-
2. Connect the signal processor to your computer
3. First turn on the signal processor and then start
-
the software. The operating software will be up-
not up-to-date.
- 4.
.
- which can be downloaded for free from our
website.
Caution:
ume of your car radio to minimum position during
connected to the signal processor until general
made. Especially if the DSP.3 will be used in fully
speakers right away.
) and install it on
-
-
21