HELIX DSP.3 Handbuch Seite 16

Connectors and control units
Line Input
1
signals.
Clipping LED
2
This LED lights up red if one of the analog
.
Input Sensitivity
3
Line and Highlevel Inputs.
Highlevel Input
4
factory radio or an aftermarket radio without
7
Ground lift switch
7
between the power ground and signal ground
of the inputs and outputs.
Control pushbutton
8
Use this button to either switch between the
Status LED
9
This LED indicates the operating mode of the
DSP and which setup has been chosen.
16
1 2
3
8 9 10 11
4 5
Optical Input
5
Optical input for digital stereo signals (SPDIF
format).
Power Input
6
Connector for the DC power supply with an
additional remote in- and output. The remote
12
USB input
10
Connects the HELIX DSP.3 to your PC.
Control Input
11
Multifunction interface for e.g. an optional
remote control or other HELIX accessory.
Line Output
12
sure that the remote output is used to turn on
6