ACO platform features
In the DCM menu of the DSP PC-Tool software in-
system features.
This function allows to determine the delay time with
setting is 0.2 seconds. The delay time should only
sound setups instead of the common two.
By using an optional URC remote control or the Con-
trol pushbutton it is possible to toggle between two
of the ten memory locations. These two memory lo-
cations can be determined in the "URC Setup Switch
DIRECTOR display remote control or the HELIX
WIFI CONTROL is recommended.
24
This function controls if the remote output (which
cuit has to be adapted to the diagnostic mode of the
radio if the latter is equipped with a so-called "class
The ADEP.3 circuit should be adjusted if there are
-