Hama Black Line Plus Bedienungsanleitung Seite 7

Note – Faulty transfer of measured
values
• In isolated cases, interference - e.g. from a WLAN
network, a computer or a television set - can
cause the transfer of measured values between the
measuring station and the base station to fail.
• In this case, you must resynchronise the stations by
brie y removing the batteries from both stations and
reinserting them.
• If the measured values are not transferred again once
the batteries are inserted, replace the batteries with
new ones.
• If necessary, select a new location for the base station
in order to avoid possible interference in the future.
6.2 Selecting the channel/other measuring stations
Note
• You can install two more measuring stations in
addition to the included measuring station. Ensure
that the base and measuring stations are set to the
same channel.
• Suitable measuring stations can be found at
www.hama.com
• Press the button (E) repeatedly to set the channel to
that set on the respective measuring station. Channel 1,
2 or 3 is displayed.
• If the symbol is displayed, the weather station will
automatically switch the displayed channel every ve
seconds.
6.3 Basic and manual settings
Automatic setting using the DCF signal
• After the rst time the base station is switched on
and successful transmission is established between
the base station and the measuring station, the clock
will automatically search for a DCF signal. During the
search, the wireless symbol (7) will ash.
6
Display
Display ashing
Displayed continuously
No display
• If the station still does not receive a signal, press and
hold the button (C) for approx. 3 seconds to start
the manual search for the DCF signal. The wireless
symbol (7) will start to ash.
Note – Time settings
• The search process takes about 7 minutes. If the search
fails, it ends and is repeated at the next clock hour.
• In the meantime you can, however, set the time and the
date manually.
• The clock automatically continues to search for the DCF
signal on a daily basis (between 1:00 a.m. and 5:00
a.m.). If the signal is received successfully, the manually
set time and date are overwritten.
• Press and hold the
approximately 3 seconds to stop the manual search.
Note – Summer time
The clock automatically switches to summer time.
S appears on the display as long as summer time is
activated.
(Manual) settings
• Press and hold the
seconds to make the following settings one after the
other:
• Year
• Month and date display
• Month
• Day
• Hour
Searching for the DCF
signal
Active
Successful – signal is being
received
Inactive
button (C) again for
button (A) for approximately 3