Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Product description
2.1
Scope of supply
The pumps are delivered ready for operation with
mains cable and operating instructions.
2.2
Product overview (01 - 03)
No.
Component
1
Filter cover
2
Filling screw
3
Pump outlet/pressure line connection
4
Motor housing
5
Power supply
6
Pump housing
7
Pump drain plug
8
Pump inlet/suction line connection
9
On/Off switch
10
Storage vessel
11
Screw-on points
12
Pressure gauge
13
LED display
2.3
Function
JET 3600
The pump draws the pumped medium directly
through the suction line connection and feeds it
to the pump outlet. It is switched on and off using
an On/Off switch.
HW 3600
The device is used for supplying water in and
around the house. After commissioning, the de-
vice switches the pump on and off, depending on
the pressure. The pump draws water via the suc-
tion line and conveys it to the storage vessel.
When the storage vessel is full, the pump switch-
es off again. If water is drawn off, the pump
switches on again automatically and conveys wa-
ter to the tapping point. The storage vessel is
then filled again.
HWA 3600
The device is used for supplying water in and
around the house. After commissioning, the de-
vice switches the pump on and off, depending on
the pressure. The pump draws water via the suc-
tion line. If water is drawn off, the pump switches
477634_a
on again automatically and conveys water to the
tapping point.
2.4
Safety and protective devices
Thermal protection switch
The pump is fitted with a thermal protection
switch which switches the motor off in the event
of overheating. After a cooling-down phase of ap-
prox. 15 - 20 minutes the pump switches on
again automatically.
2.5
Dry running protection (HWA 3600)
The pump is equipped with dry running protec-
tion. The dry running protection system switches
off the pump if water is not drawn in or the suc-
tion line is damaged. The pump then tries to
switch itself on again automatically several times.
2.6
Pressure sensor (HWA 3600)
The pump is equipped with a pressure sensor.
This sensor automatically switches the pump off
and on when the set pressure is reached.
■
Set pressure: see technical data.
2.7
LED display (HWA 3600)
The pump is equipped with an LED display
(03/13) to signal operating states and error mes-
sages. Malfunctions can be acknowledged by
pressing the reset button (06/1)
2.8
Intended use
The pump is intended for private use in house
and garden. It must only be operated within the
scope of its usage limitations in accordance with
the technical data.
The pump is suitable for:
■
Watering the garden and premises
■
Re-pumping and pumping out of vessels (e.g.
swimming pools)
■
Removing water from fountains, rain barrels,
and cisterns.
HW 3600 / HWA 3600
■
Automatic domestic water supplies
■
Water supply pressure boosting.
NOTE The local regulations must be ob-
served if the pressure of the water supply is in-
creased. Information is available from your local
plumbing specialist.
The pump is suited exclusively for the conveying
of the following fluids:
■
Clear water, rainwater
17
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
