Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Congratulations!
With your purchase you have decided on a high-
quality product. Get to know the product before
you start to use it. Carefully read the following
instructions for use. Use the product only as descri-
bed and only for the given areas of application.
Keep these instructions safe.
When passing the product on to a third party,
always make sure that the documentation is
included.
contents (figure a)
1 x Self-inflating hiking mat (1)
2 x Straps (2)
1 x Instructions for use
technical data
Dimensions (inflated): approx. 186 x 51 x 2.5cm
(L x W x H)
Maximum load capacity: 110kg
correct use
This article is for use on the floor in the camping
and trekking sector. It was developed for one
person with a maximum weight of 110kg and for
private use.
Safety notes
warning!
Danger of suffocation for children! Do not allow
children to play with the packaging material or
the article without supervision.
risk of injury!
• Only use the apparatus for its intended use.
• Never use the article close to open fires or
stoves.
• The article may not be used in water or for
swimming! It will not provide support on the
surface of the water and is not a suitable swim-
ming aid. Water that contains salt or chlorine
can damage the surface of the article.
• Please note the maximum load capacity.
Exceeding the weight limit can cause damage to
the product and compromise its functions.
4
GB
• Inspect the article for damage or wear before
each use. The article may only be used while in
perfect condition. Do not use the article if there
is visible or suspected damage.
• Do not use the product if it is no longer able to
hold air.
avoiding damage
• Avoid contact with sharp, hot, pointed, or
dangerous objects.
Inflating with air
1. Remove the article from the packaging and
pull the elastic straps over the outer edges of
the article (figure B).
2. Spread the article out on the floor (figure D)
and open the valve stopper by turning it anti-
clockwise (figure C). The article will automati-
cally inflate with air.
Important! the valve stopper may not be
removed!
3. Turn the valve stopper clockwise once there is
enough air in the article (figure C).
note: the article should be inflated
briefly by mouth before the first use so
that the filling can expand a little.
the automatic inflation of the article with
air can take a little longer if it has been
stored rolled up for a long period of time.
the degree of hardness of the article
can be increased by further inflation by
mouth.
removing the air
1. Open the valve stopper by turning it anti-clock-
wise (figure C).
2. Push the air out of the article by folding the
article in the middle and rolling it up so that the
air escapes (figure D).
Important: roll the article up from the
opposite end towards the valve.
3. Close the valve stopper by turning it clockwise
(figure C).
4. Pull the elastic straps over the outer edges
around the article (figure B).
Werbung
Inhaltsverzeichnis
