Menu Displays For Video Out Output; Specifications - Panasonic AG-EC4 Bedienungsanleitung

Menu displays for VIDEO OUT output

When this unit is connected to the remote connector of the camera recorder:
Setup menu is displayed in the images output from the VIDEO OUT connector when the MENU
switch is set to ON, and the CHARA button is set to ON.
This menu screen is characters superimposed on the composite signal of the camera recorder.
When this unit is connected to the remote connector of the base station:
The displayed image is the result of converting the display of the SDI signal output from the
camera recorder to a composite signal. Be sure to superimpose the menu display on the SDI
signal of the camera recorder.
For how to superimpose the menu display on the SDI signal of the camera recorder, refer to the
operating instructions of the camera recorder.
<Note>
The chromatic level of the video signal will be decreased when the 50 meter remote cable is
used.

Specifications

Power requirements: DC 12 V
Power consumption: 2.5 W
indicates safety information.
[General]
Allowable ambient temperature:
0 °C to 40 °C (32 °F to 104 °F)
Storage temperature:
-20 °C to 60 °C (-4 °F to 140 °F)
Allowable relative humidity:
10 % to 85 % (relative humidity)
Dimensions (W a H a D):
82 mm a 56 mm a 180 mm
3.2 inches a 2.2 inches a 7.1 inches
(excluding knobs)
Weight:
approx. 630 g (approx. 1.4 lb)
[Input/Output]
CAM/BS:
Round 10 pin
E-11
(11 V - 17 V)
[Output]
VIDEO:
BNC
VBS, 1V[P-P], 75 h
[Supplied Accessories]
Remote cable 10 m
Weight and dimensions when shown are
approximately. Specifications are subject to
change without notice.