Advice On Disposal; Troubleshooting - Bosch sensixx B45L serie Gebrauchsanleitung

Advice on disposal
Our goods come in optimised packaging. This
basically consists in using
materials which should be handed
over to the local waste disposal service as secondary
raw materials. Your local town council can give
you information about how to dispose of obsolete
appliances.
This appliance
accordance with European Directive
2002/96/EG concerning used electrical
and electronic appliances (waste
electrical and electronic equipment -
WEEE).
The guideline determines the framework for
the return and recycling of used appliances as
applicable throughout the EU.
Trouble shooting
Problem
The display does not
react when touched.
" " icon lashes
icon lashes.
" " icon lashes.
When touching the
display, the beep
cannot be heard.
The steam generator
does not come on.
The iron does not heat
up.
The iron begins to
smoke when switched
on.
non-contaminating
is labelled in
Possible causes
• Dirt on the display.
• Fingers too cold.
The steam release button (13)
on the iron handle has not been
pressed during the last 8 minutes,
and the auto shut-off system has
been activated.
Water tank is empty and must be
illed.
Boiler and ilter must be rinsed.
The beep has been deactivated.
• There is a connection problem.
• The main power button is not
switched on.
• The main power button is not
switched on.
• The temperature is set to a low
position.
• During irst use: certain
components on the appliance
have been lightly greased at the
factory and may produce a little
smoke when initially heated.
• During subsequent use: the
soleplate may be soiled.
Solution
• Clean the display with a damp cotton
fabric (not too wet).
• Warm your ingers a little bit and try
again.
Press the steam release button again to
switch the steam station back on.
Fill the water tank.
Rinse the ilter and the boiler according
to the cleaning instructions in this manual
(see section F).
Activate it according to instructions in this
manual.
• Check the mains cable (5), the plug and
the socket.
• Set the main power button (9) to the "I"
position (illuminated in red).
• Set the main power button (9) to the "I"
position (illuminated in red).
• Set the temperature to the desired
position.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.