C.M.A. GLORIA AL Bedienungsanleitung Für Den Benutzer Seite 157

Cappuccino maker
Use special care in cleaning the cappuccino maker, following the procedures
indicated here:
• initially wash by placing the immersion tube in water and run a delivery
for a few seconds;
turn the rotating body (1) 90° to pos.B (closure of milk outlet duct);
•
• holding the aspiration tube in the air, dispense steam (cappuccino maker
dry run);
• wait about 20 seconds to allow for internal cleaning and sterilisation of
the cappuccino maker;
• close the steam and put the rotating body back in pos.A;
• if the air intake hole is blocked (2), clear it gently with a pin.
It is advisable to clean the cappuccino after each period of con-
i
tinued use so as to avoid malfunctions and to ensure the hygiene
of the system
C
hecks and Maintenance
To ensure perfect safety and efficiency of the machine over time, it is necessary to carry out maintenance. In particular,
it is advisable to ask Technical Service to carry out an overall check of the machine at least once a year.
Automatic
Check the following on a regular basis:
• check pump pressure with a pressure gauge which should indicate a pressure of around 8-9 bar. In case of
anomalies contact technical service;
• also with a pressure gauge, check the boiler pressure, which should be about 0.8-1.2 bar. This may also require
the assistance of technical service;
• check the wear of the filters, if there is damage to the edges and check if coffee grounds are getting into the cup.
If necessary replace the filters.
Grinder-doser
Check the following on a regular basis:
• check the dose, which should be about 6-7 gr. at a time and adjust the amount as necessary;
• always monitor the degree of grinding and modify as required;
• check the wear of the grinders. They will need to be replaced if there is too much powder in the ground coffee
(the grinders usually last for about 600 kg of coffee).
Softener
Do the following on a weekly basis:
• perform regeneration of the softener as described in chapter 9 (for the softener in the manual version);
• check that there is salt in the container (for the softener in the automatic version);
Multihead anti-lime system
Check proper lighting of the green LED and check if any other LEDs are on:
- LED green system OK
- LED red system partially out of order (*)
- LED off system completely out of order (*)
(*) contact technical service
1
CONTROLS - MAINTENANCE
pos. A
2
pos. B
9