Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WX 50, WX 60, and WXC 500 QUICK START
Advertise Local subnet.
By default, the device's local subnet is not advertised to the other WX devices in the community. As a result, data destined for
this subnet is not reduced — even if there is a WX device in the path.
•
If you want other WX devices to reduce data destined for this subnet, select the Advertise checkbox.
If you choose not to advertise the local subnet, you should review the Reduction Subnets page of the Web console
after completing the Quick Setup.
•
In the Device name field, you can assign a name for the device.
•
Click Next to continue.
Enter a license key.
By default, each device has a 30-day evaluation license. When the evaluation license expires, data will pass through the
device without reduction.
Where to go next:
If you have purchased the device, you can use the serial number to obtain a permanent license key through the Online
License Service. The License Key server is accessible by clicking Online Service or by calling Support at 1-888-314-JTAC (or
408-745-9500).
•
Enter the permanent license key in the License key field.
•
Click Next to continue.
Change Administrator password.
›
•
Enter a new Administrator password in the New password and Verify new password fields, and then click Finish.
NOTE: If you deselect the "automatic save" option, configuration settings will be reset by the next power cycle.
Initial configuration is complete and you are now ready to configure policy settings for the device. Refer to the Sequence
Reducer/Sequence Mirror Operator's Guide , which is located on the Documentation/Utilities CD. For additional product
support information, visit our Web site at http://www.juniper.net/support.
ˆ
‰
Werbung
Inhaltsverzeichnis
