Cleaning And Care - WMF Kult X Gebrauchsanweisung

Cleaning and care

Clean all parts immediately after use and remove any food residue straight away.
Never wash or rinse the motor! Do not immerse it in water! Always remove the mains plug before
cleaning.
Risk of injury! The cutting blades and discs are sharp! Do not touch! Be
careful when cleaning the cutting blades and discs!
Do not use any corrosive, alcohol-based or caustic cleaning products or utensils containing solvents
(e.g. scouring pads or similar). These could scratch the surface.
The individual parts must be completely dry before use.
Dishwasher-safe
Stopper (1)
Lid (2)
Drive shaft (3)
Preparation container (4)
Motor unit (5)
Stainless steel blade (7)
Cutting discs (8 – 11)
Emulsifying disc (12)
Kneading blade (13)
18
Can be rinsed Wipe with a
under running damp cloth
water
For UK use only
▪ This product is supplied with a 13 A plug conforming to BS 1363 fitted to the
mains lead. If the plug is unsuitable for your socket outlets or needs to be
replaced, please note the following. If the plug is a non-rewireable one, cut
it from the mains lead and immediately dispose of it. Never insert it into a
socket outlet as there is a very great risk of an electric shock.
▪ The replacement of the plug at the mains lead has to be done according to the
following instructions:
Important: The wires in this mains lead are coloured in accordance with the
following code:
blue Neutral
brown Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
⋅ the wire which is coloured blue must be connected to the terminal which
is marked with the letter N or coloured black,
⋅ the wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
Do not connect any wire to the terminal which is marked
with the letter E or by the earth symbol , or coloured green or green and
yellow.
▪ If a 13 A (BS 1363) plug is used it must be fitted with a 13 A fuse conforming
to BS 1362 and be ASTA approved. If any other type of plug is used, the
appliance must be protected by a 10 A fuse either in the plug or adapter or at
the distribution board.
If in doubt - consult a qualified electrician.
▪ Never use the plug without closing the fuse cover.
The appliance complies with European directives 2014/35/EU, 2014/30/EU and
2009/125/EU.
At the end of its life, this product may not be disposed of in normal household
waste, but must instead be taken to a collection point for recycling electrical and
electronic appliances.
The materials are recyclable in accordance with their labelling. Reuse, recycling
and other ways of reutilising old appliances make an important contribution to
protecting our environment.
Please ask your local authorities for information about the appropriate disposal
point.
End users are personally responsible for deleting any personal data that may be
stored on appliances they are disposing of.
Subject to change
19