General Information; Overload Protection; Cleaning And Maintenance - WMF Profi Plus Gebrauchsanweisung

required setting. This prevents the ingredients from spraying out.
Electronic speed regulation
The appliance is equipped with an electronic speed regulator that is used to keep
the speed constant under different loads.
Splash guard
▪ Push the locking lever on the mixer arm upwards and hold it. At the same
time tilt the mixer arm backwards until it locks into place.
▪ Push the required mixer accessory into the attachment as far as it will go and
rotate it until it locks.
▪ Place the bowl on the base. Make sure that the handle on the bowl is facing
the front of the appliance, then gently turn the bowl clockwise until it locks
into place.
Note: The bowl locks into place easily, do not use force when turning it.
▪ Push the locking lever on the mixer arm upwards and at the same time lower
the mixer arm.
Place the splash guard without fill opening on the bowl.
You can now place the fill opening on the splash guard.
Note: During mixing, you can add further ingredients directly through the
opening on the splash guard.
Removing the splash guard
▪ Set the speed regulator to the Off position (0).
▪ Remove the fill opening.
▪ Remove the splash guard.

General information

▪ The appliance is equipped with a safety function. It only starts once the mixer
arm is correctly lowered into position and the lid of the front attachment is
placed on it.
▪ If the mixer arm is moved backwards during operation, the appliance stops. To
restart it, you must lower the mixer arm back into position and turn the speed
regulator to the Off position (0). You can then select the required speed/func-
tion again and the appliance will start automatically.

Overload protection

The appliance is equipped with overload protection. This prevents the motor
being damaged by overloading.
If the appliance switches off during operation, proceed as follows.
▪ Set the speed controller to the Off position (0), pull out the mains plug and
leave the appliance to cool down for 20-30 minutes.
▪ Once the appliance has cooled down, insert the mains plug into the socket
again and continue with the process.

Cleaning and maintenance

Turn the speed regulator to the Off position (0) and remove the plug from the
mains supply. Do not immerse the appliance in water, but rather clean it using a
damp cloth with a little washing-up liquid and then dry it.
Do not use harsh and abrasive cleaning agents.
You can rinse the mixer accessories and the splash guard under running water.
For easy cleaning, you can also wash the mixer bowl in the dishwasher.
18