Ascaso I.1 Handbuch Seite 8

MOLI 6ID 2007.qxp
I.1 / I.2 / I.3 (mini) Models
operation
Assemble the coffee bean hopper
on its position.
Fill it with coffee beans in such an amount
as to be consumed on a daily basis. Put
the hopper lid
Connect the power cord
Push the ON-OFF switch
machine on. The built-in led will be on.
The grinder will then be ready for grin-
ding.
Only models with a timer device (NO USA),
allows the operator to adjust in advance
the grinding time (a minimum of 8 se-
conds and a maximum of 60 seconds) by
using regulator
coffee is required, the machine filter hol-
der must be placed under the coffee spout
8
Turning the timer regulator
will result in an increase of grinding time,
whereas turning it counterclockwise de-
creases grinding time.(FIG.1)
14
Downloaded from www.Manualslib.com
20/09/2007 13:29 PÆgina 14
We recommend that grinding time must be
set for a production equivalent to 7g /
0.25 oz of coffee: between 20 and 25 se-
3
conds. Check the adjustment, which may
vary depending on type of coffee and grin-
ding discs wear.
on its position.
2
Once the dose is on the filter holder, press
the coffee by using a manual tamper for
to the mains.
7 brewing your espresso.
I.1D / I.2D Models operation
to turn the
1
Connect the power cord
Push the ON-OFF switch
machine on. The built-in led will be on and
the grinder will then start grinding coffee,
which will be stored at the dose dispenser
12 .
Push the ON-OFF switch
. Every time ground
6
machine off and stop grinding coffee.
For having the ground coffee dose dis-
and guided by the switch holder fork
pensed, the machine filter holder must
, pressing the switch .
9 10
be placed on the support fork
clockwise
6
Pull the dose dispenser lever to get a cof-
fee dose (7-8 g / 0.25-0.28 oz) allowing
the lever to return to its former position by
itself.
Once the dose is on the filter holder, press
the coffee by using a manual tamper for
brewing your espresso..
manuals search engine
4. Grinding point and
regulation
The grinding point (coarser or finer) will
depend on the coffee blend quality
used, its roasting point, humidity (the
more humid the conditions are the coar-
ser the grinding point must be) and cof-
fee machine conditions.
Therefore, it is necessary to adjust the
grinding point periodically (on a daily ba-
to the mains.
7
sis). To do that we must use the grinding
regulator located on the upper right
5
to turn the
1
side of the machine. If we turn the regu-
lator forward (clockwise) we will obtain a
finer grinding, whereas turning it back-
wards (counterclockwise) will result in a co-
arser grinding point.(FIG.2)
to turn the
1
.
13
The grinding point is factory adjusted for
a medium grinding point. It is therefore ne-
cessary to proceed with a preliminary grin-
ding adjustment to achieve the best grin-
ding quality.
It is recommended that you check the es-
presso coffee result on the cup and its
taste, taking into consideration that an
excessively coarse regulation results in
lighter coffees (watered) with neither aro-
ma nor cream, whereas an excessively
fine regulation results in short shots,
strong and dense in excess.
15