Electrical Connection - Beem Cater Pro B8.001 Bedienungsanleitung

EN
Requirements for the place of use
For safe and trouble-free operation of the
appliance, the place of operation must sat-
isfy the following requirements:
■ Place the appliance on a level, heat
resistant surface that is also resistant to
splashing fat.
■ The surface finishes on furniture may
contain substances that can be detri-
mental to the feet of the appliance. If
necessary, place a mat under the feet of
the appliance.
■ Do not place the appliance in a hot,
wet or very humid environment or in
the vicinity of inflammable materials.
There must be a gap of at least 15 cm
between the appliance and any walls,
furniture or other objects.
■ Select a location that does not allow
children to reach the hot surfaces of the
appliance.
■ The mains socket must be easily acces-
sible and allow fast disconnection in the
event of an emergency.
BEEM - Elements of Lifestyle

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on the
electrical connection must be be observed:
■ Before connecting the appliance, com-
pare the connection data (voltage and
frequency) on the rating plate with those
of your mains power supply. The data
must correspond in order to avoid dam-
age to the appliance. If in doubt, ask
your electrical appliance retailer.
■ The mains socket must be protected by
at least a 10 A automatic circuit breaker.
■ Ensure that the mains lead is undam-
aged and is not laid over sharp edges.
■ The mains cable must not be pulled
tightly, bent or come into contact with
hot surfaces.
■ Route the cable to prevent risk of trip-
ping.
■ If the appliance is to be connected to
the power supply via an extension lead,
the cable cross-section must be at least
1.5 mm².
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
Cater Pro
21