Electrical Connection - Beem Pro-Multi-Grill 3 in 1 V2 Bedienungsanleitung

BEEM - Elements of Lifestyle
Do not cut any food on the grill
►
plate.
Only use spoons and spatulas
►
suitable for non-stick surfaces to turn
over food.
Intended use
This appliance is intended to be used for
grilling and roasting food in the household or
similar, non-commercial establishments such
as staff kitchens in shops, cafés, offices or
other business establishments; agricultural
establishments; use by guests in hotels,
motels or other residential facilities; bed and
breakfast establishments.
Any use other than previously stated is con-
sidered as improper use.
WARNING
If not used for its intended purpose and/or
used in any other way, the appliance may
be or become a source of danger.
► Use the appliance only for its intended
purpose.
► Observe the procedures described in
this user manual.
No claims of any kind will be accepted for
damage resulting from use of the appliance
for other than its intended purpose.
The risk must be borne solely by the user.
Requirements for the place of opera-
For safe and trouble-free operation of the ap-
pliance, the installation location must satisfy
the following requirements:
Place the appliance on a stable, level,
‹
heat resistant surface that is also resistant to
splashing fat.
The surface finishes on furniture may
‹
contain substances that can be detrimental to
the feet of the appliance. If necessary, place
a mat under the feet of the appliance.
Do not place the appliance in a hot, wet
‹
or very humid environment or in the vicinity of
inflammable materials. There must be a gap
of at least 15 cm between the appliance and
any walls, furniture or other objects.
tion
Never place the appliance or parts of
‹
the appliance in the vicinity of strong heat
sources and hot surfaces (e.g., heating,
oven, grill).
Do not place the appliance on the edge of
‹
the table. It could fall down.
The mains socket must be easily accessi-
‹
ble and allow fast disconnection in the event
of an emergency.
Top prevent the appliance from slipping
‹
away, do not lay tablecloths, cloths or servi-
ettes under the feet of the appliance.
The appliance may not be used or stored
‹
outdoors.

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on the
electrical connection must be observed:
Before connecting the appliance, com-
‹
pare the connection data (voltage and
frequency) on the rating plate with those of
your mains power supply. This data must cor-
respond in order to avoid damage to the ap-
pliance. In case of doubt, ask your electrical
appliance retailer.
The mains socket must be protected by at
‹
least a 16A fuse.
Ensure that the mains cable is undam-
‹
aged and is not laid over sharp edges.
The mains cable must not be pulled
‹
tightly, bent, crushed or knotted or come into
contact with hot surfaces.
Route the mains cable to prevent risk of
‹
tripping.
If the appliance is to be connected to the
‹
power supply via an extension lead, the cable
cross-section must be at least 1.5 mm².
The electrical safety of the appliance is
‹
only assured when it is connected to a prop-
erly installed protective earth (PE) conductor
system. Connection to a mains socket with-
out PE conductor is forbidden. If in doubt, the
electrical system must be checked by a quali-
fied electrician. The manufacturer assumes
no liability for injury or damage caused by a
missing or interrupted protective earth con-
ductor.
EN 13