Sony DFR-C3000 Handbuch Seite 22

Software Operation
20(E)
Downloaded from www.Manualslib.com
Audio Monitor Select column
Selects the audio signal output to the ANALOG OUT connector.
• When you click Main, ATRAC-encoded main channel is output.
• When you click DCM, ATRAC-encoded concealment channel is output.
• When you click Input, input audio channel is output as is.
Measurement column
Select the unit for displaying the current position.
Current Position column
Displays the current recording position.
The contents of this column changes only during recording.
The contents of each box change according to the setting of Measurement
column as follows:
Information displayed in the Current Position column
Box title
Time Code
Film Length
Time From
Start
Remaining
Remaining
Time
Event column
Specify the start and stop position for the automatic recording.
TC Type box
Select Time Code or Feet/Frame for the unit for measuring events.
• When you select Time Code, events are measured in accordance with
input time code.
• When you select Feet/Frame, events are measured in accordance with
total length of transport from the beginning of the film.
Start Time box
Specify the recording start time if Time Code is selected for TC Type box.
Stop Time box
Specify the recording stop time if Time Code is selected for TC Type box.
manuals search engine
Selection in the Information
Measurement column
—
The current time code on the master
tape in hours, minutes, seconds and
frames.
Feet/Frame The film length from the recording
starting point in feet and frames.
Time The time that has elapsed since the
start of recording in hours, minutes,
and seconds.
Feet/Frame The remaining film length up to the
recording stopping point in feet and
frames.
Time The remaining time up to the recording
stopping point in hours, minutes and
seconds.