National Geographic 265NE Bedienungsanleitung Seite 6

With all wireless devices, the receiving ability may be affected by, but not limited to,
the following, therefore for best accuracy avoid the following situations:
• Nearby mountains and valleys
• Among tall buildings
• Near railway, high voltage cable, etc.
• Near freeway, airport, etc.
• Near construction site
• Inside concrete buildings
• Near electrical appliances
• Bad weather
• Inside moving vehicles
• Nearby metallic structures
1. Touch the TIME section on the monitor, + and – buttons will start to fl ash.
2. Press the + button for your desired time zone, 0 for GMT+1 time zone, 1 for
GMT+2 time zone, -1 for GMT time zone.
3. Touch the TIME section to confi rm.
4. Follow steps 2-3 to set 12/24 mode, hour and minutes.
NOTE: Time zone can be adjusted up to +12 and -12. NOTE:
1. Touch the DATE section on the monitor, + and – buttons will start to fl ash.
2. Touch the + or – buttons to shift between alarm time, date with year and date
with day of the week.
3. Touch the DATE section to confi rm, + and – buttons will start to fl ash.
4. Touch the + or – buttons to shift between DD-MM format and MM-DD format.
5. Touch the DATE section to confi rm.
6. Repeat steps 4-5 to set the year, month, day, alarm hour, alarm minute. Touch
ON/OFF to enable or disable the time alarm.
1. Touch the INDOOR TEMPERATURE section, + and – buttons will start to fl ash.
2. Touch the + or – buttons to change the measurement from Celsius to Fahrenheit
3. Touch the INDOOR TEMPERATURE section to confi rm.
4.1 Indoor Temperature Alarm 4.1 Indoor Temperature Alarm
4. The indoor temperature high alarm icon (HI AL) will start to fl ash as well as the +
and – buttons.
5. Touch the + or – button to change the value, touch the ON/OFF button to enable
or disable the alarm. Touch the INDOOR TEMPERATURE section to confi rm.
6. Follow step 5 to set the indoor temperature low alarm (LO AL).
7. Once the temperature alarms are set, the maximum indoor temperature will be
8. To reset the maximum temperature touch and hold the fl ashing maximum value for
3 seconds, the value will reset to the current reading.
9. Touch the INDOOR TEMPERATURE section to confi rm.
10. Follow steps 8-9 for minimum readings.