Removing And Replacing The Side Panels - Dell PowerEdge 4820 Installationsanleitung

d
e
Replacing the Back Doors
To replace the back doors, perform the steps for removal in reverse.

Removing and Replacing the Side Panels

CAUTION:
before running systems in the rack to ensure proper cooling within the rack.
NOTE:
stabilizer feet.
NOTE:
systems in a rack, having the sides open makes it easier to install slide assemblies
and support rails and to reverse the direction that the front door opens.
Removing the Upper Side Panels
1 Pull both latches up and swing the bottom end of the panel away
from the rack.
2 Grasp firmly on each side of the panel.
3 Lift the panel upward until the panel lip clears the top of the rack.
4 Lay the panel in a safe location with the panel's outer surface facing
upward to help prevent damage to its cosmetic coating.
5 Repeat step 1 through step 4 for the other upper side panel.
Replacing the Upper Side Panels
1 Lift the upper side panel up onto the rack, hooking the panel lip over
the top of the rack (see Figure 1-4).
2 Swing the bottom of the panel downward onto the rack.
3 Press the panel into the rack until both latches lock into place.
12
Downloaded from www.Manualslib.com
Lay the door in a safe location with the door's outer surface
facing upward.
Laying the door flat with the outer surface facing upward helps
prevent damage to its cosmetic coating.
Repeat step a through step d for the left back door.
For stand-alone racks, reinstalling the side panels is necessary
You must remove the lower side panels in order to install the side
Although removing the side panels is not mandatory for installing
Installation Guide
manuals search engine