S20 - Bosch DAS 3000 Reparaturanleitung

Procedure following successful check
 Check the magnetic indicator bar.
 Check the calibration board retainer.
 Check the DUAL -Board and additional calibration boards.
 Check reference board for distance measurement.
 Check the reference board for driving axis alignment.
 Check the alignment aid.
 Rule out operator errors.
---
Procedure following unsuccessful check
 Check for defective camera in the edge protection frame.
 Check the edge protection frame.
---
2.3 Checking the cameras on the DAS 3000 S20
The cameras are checked with the aid of the service menu. Service menu password: ia4kd
---
1. Position the hammerhead nuts for the mounting
2. Secure the mounting with knurled screws (2).
3. Level the mounting by placing the spirit level on the mounting.
2 2
1
(1) Mounting for P-Assist S5 line laser
(2) Knurled screws with hammerhead nuts
4. Position the P-Assist S5 line laser
(3).
1
3
(1) P-Assist S5 line laser
(2) Mounting for P-Assist S5 line laser
(3) Arrestor cable
5. Start Bosch ADAS Positioning.
Robert Bosch GmbH
(1)
in the profile slot of the edge protection frame.
(1)
on the securing pins on the mounting
2
DAS 3000 | 23 | en
(2)
and secure with arrestor cable
1 689 975 292 | 2020-02-28