Bosch DAS 3000 Reparaturanleitung Seite 22

en | 22 | DAS 3000
1
3
(1) P-Assist S5 line laser
(2) Mounting for P-Assist S5 line laser
(3) Arrestor cable
5. Start Bosch ADAS Positioning.
6. Open "Settings".
7. Open the "Service menu".
8. Enter password ia4kd.
9. Select "DAS 3000 S10" as product.
10. Enter the serial number of the DAS 3000 S10.
The serial number is located on the type plate, which is attached above the mounting for the laptop/tablet.
11. Switch on the P-Assist S5 line laser.
12. With the aid of the line laser, center the reference board for the distance measurement in front of the DAS 3000
at a distance between 2.40 to 2.60 m.
The reference board for the distance measurement must be fully visible in the camera image.
1
(1) Reference board for distance measurement: centered in front of the DAS 3000 S10 on the alignment aid
(2) P-Assist S5 line laser
13. Start test.
---
1 689 975 292 | 2020-02-28
2
2
Robert Bosch GmbH