FLAEM NebuAir+ Bedienungsanleitung Seite 5

"Connection diagram" in point C1. Insert the Speed selector with valve (C1.4) in the up-
per part (C1.3) as shown in the "Connection diagram" in point C1. Pour the medication
prescribed by the doctor into the lower part (C1.1). Close the nebuliser by turning the
upper part (C1.3) clockwise.
3. Connect accessories as indicated in the "Connection dia-
gram" on the cover.
4. Sit comfortably holding the nebuliser in your hand, place
the mouthpiece onto your mouth or alternatively use the
nose piece or mask. Should you opt for the mask accessory,
place it on your face as shown in the picture (with or with-
out using the elasticated strap).
5. Start the device by means of switch (A1) and breathe deep-
ly in and out. After inhaling, we recommend holding your
breath for an instant to allow the inhaled drops of aerosol to deposit. Then exhale slowly.
6. Upon completing application, switch off the device and unplug it.
ATTENTION: If after the therapy session an evident deposit of moisture forms within the
pipe (B), detach the pipe from the nebuliser and dry it with the very ventilation from the
compressor; this operation prevents possible blooms of mould inside the pipe.
USE METHODS OF THE RF7 DUAL SPEED PLUS NEBULISER WITH SPEED SELECTION
AND VALVULAR SYSTEM
It is professional, quick, recommended to administer all types of medications, including
the costlier ones, even in patients with chronic diseases. Thanks to the
geometry of the RF7 Dual Speed Plus nebuliser cup internal ducts, we
have obtained a recommended, active particle size to treat even the
lower respiratory tract.
For faster inhalation therapy, position the valve speed selector (C1.4)
pressing on the word MAX with your finger.
For more effective inhalation therapy, position the valve speed selector
(C1.4) pressing on the opposite side of the word Max with your finger.
In this case, you have optimal assumption of the medication, minimising
leaks into the surrounding environment, thanks to the valvular system
with which the nebuliser cup, mouthpiece and mask are equipped.
SOFTTOUCH FACE MASKS
Soft
biocompatible
material
Dispersion
Limiting Vent
During inspiration the vent
bends inwards.
The new SoftTouch Masks feature an adaptive edge made
of a soft biocompatible material ensuring an excellent
adherence to the face and a Dispersion Limiting Vent.
These innovations, which make them stand out from the
rest, allow increased sedimentation of medication in the
lungs and reduced dispersion into the air.
3
During expiration the vent bends
outwards.
MAX