Team Kalorik TKG SKV 1004 Gebrauchsanleitung Seite 38

Copies of the I/B. Please reproduce them without any changes except
under special instruction from Team International BELGIUM. The pages
must be reproduced and folded in order to obtain a booklet A5 (+/-
148.5 mm width x 210 mm height). When folding, make sure you keep
the good numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
Fax +32 2 359 95 50
USE
DANGER! Do not use the product while it is charging.
•
DANGER! Never touch the rotating parts of the floor brush during operation.
•
• Remove the water tank (Ill. 6) by first using the switch (11) and opening the water tank casing
(12). Remove the water tank (3) using the handle (2). Open the locking clips (5) and remove
the lid (4).
• Pour clean water in the tank, up to the mark.
Close the lid (4) again and put the water tank (3) back into the main unit.
•
• Press the on / off switch (1) on the handle (8) of the main unit to switch on the device. Use the
ECO switch (2) to change the speed levels.
Note:
3. During cleaning, foam may form in the water tank. The performance of the device is not
affected by slight foaming.
4. Detergent, soap powder, bleach and the like MUST NOT be added to the water tank.
Press the on / off button (1) again to switch off the appliance.
•
• During short breaks, you can stop the vacuum cleaner by tilting the appliance slightly
forward.
Note: Make sure that the vacuum cleaner is on a level, non-slip surface before releasing it, to
prevent it from falling over and causing possible damage to the unit or floor.
ATTENTION! Turn off the vacuum cleaner before each shutdown, otherwise the rotating bristles may
permanently damage your (carpet) floor.
The floor brush is suitable for the daily cleaning of larger surfaces, hard and smooth floors or
•
carpets.
The hand vacuum cleaner is suitable for mattresses, sofas, curtains and wallpapers. Press the
•
release button (3) on the main unit to remove the handle (4) (Ill. 7, Fig. 8). Switch on the
device by pressing the on / off switch (5) on the hand vacuum cleaner.
Never use the hand vacuum cleaner to vacuum water or other liquids.
•
BATTERY WARNING
Blue - Battery full
•
Blinking blue - Less than 20% battery remaining
•
• Blinking red - Low battery status
CLEANING AND CARE
Switch off the appliance before each cleaning.
•
• Wipe the housing of the hand vacuum cleaner and the main unit with a soft, dry cloth.
Persistent stains can be removed with a damp cloth and some detergent. Dry the cleaned
•
area completely afterwards.
Change the water in the tank while using the vacuum cleaner as soon as it is dirty and after
•
each use at the latest. To do this, press the release switch (11) and remove the water tank (Ill.
10, Fig. 13). Proceed as for filling the water tank. Empty the water tank and clean it thoroughly
with water.

Back cover page (last page)
Assembly page 37/40