Electrical Installation - Johnson Pump SPX Flow Viking Power 16 Bedienungsanleitung

I
nstallation and maintenance
Installation
Locate the pump in a dry location.
be above the pump house
with the enclosed stainless steel washer. Make
sure that the plastic spacers are in their correct
too tight if the pump house is in contact with the
surface.)
the pointed end towards the flow direction. See the
drawing.
to quick disconnect fittings and other hose barbs
in the system.
Pump configuration
ways:
procedure:
steel foot
2. Set the pump with the motor facing in the de-
sired direction
3. Fasten the six screws

Electrical installation

voltage DC installation for continuous current).
Note: The fuse must be ignition protected.
protection is automatically restored when the mo-
tor is cooled.
If the pump is connected with separate earth lead,
this should be yellow/green and connected to the
correct installation. Negative wire must be black.
Choose wire size in accordance with total wire
must be sealed with a marine sealant.
Original instructions
Note: Before installation with electrical con-
trol systems, check that equipment to be
used is of sufficient rated capacity to accept
amperage draw of motor. Low voltage will
cause motor to overheat.
Maintenance
be regularly cleared from debris to prevent reduced
performance.
-
opening the house. Make sure pump is discon-
nected from the power supply.
Wiring diagram
Max 0.2 m
Black
Green/yellow
Other electrical devices, eg switch, circuit
breaker, must be installed between the pump
red wire).
Wiring dimensions
Wire size
1.0 mm² #18 AWG
1.5 mm² #16 AWG
2.5 mm² #14 AWG
-
Self-priming
Pump is self-priming up to 3 m/10 feet.
Dry running
however unnecessary reduce your battery power.
> English
Red
fuse
Pump
Max wire length* in m
12V 24V
13
20
34 140
56
84
7