Switching On / Off / Selecting The Temperature; Temperature Levels; Automatic Switch-Off; Cleaning And Care - Silvercrest P10B Bedienungsanleitung

Fix it in place with the elastic strap and hook-
and-loop fastener (see Fig. C). To do this, first
lay the long elastic strap of the hook-and-loop
fastener around your stomach. Then place the
other end of the heating pad over the top.
Switching on / off / Selecting
the temperature
To begin, first connect the control
heating pad with the plug-in connector
(see Fig. B).
Switching on:
Set the control unit
or 6 to switch on the heating pad.
Note: The function indicator
the heating pad is switched on.
Note: This heating pad features rapid heating,
which allows it to heat up within the first 10 minutes
of operation.
Switching off:
Set Level 0 on the control
heating pad off.
Note: The function indicator
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature level (Level 6). This will
cause the heating pad to warm up quickly.
If you wish to use the heating pad over several
hours, set the lowest temperature level (Level 1).

Temperature levels

Set the required temperature level on the
control
(see Fig. A).
1
Level 0: off
Level 1: minimum heat
Level 2–5: customised heat
Level 6: maximum heat
66182_silv_Heizkissen_Content_LB4.indd 9
to the
1
3
to setting 1, 2, 3, 4, 5
1
illuminates after
2
to switch the
1
ceases to illuminate.
2
Operation / Cleaning and care

Automatic switch-off

Note: The heating pad switches itself off auto-
matically after about 90 minutes. The function
indicator then starts to flash.
2
Then select the setting "0" and after about
5 seconds, reset the heating pad to the desired
temperature setting to switch it on again.
Switch the heating pad off (setting "0") and
pull the mains plug out of the mains socket if
the heating pad is not to be used after it has
switched itself off automatically.

Cleaning and care

TO LIfe BY eLeCTRIC SHOCK!
Always remove the mains plug from
the socket and the plug-in connector
the control from the heating pad (see Fig. B)
1
before cleaning the heating pad.
DANGeR Of eLeCTRIC SHOCK!
Do not reconnect the control
the heating pad until the plug-in con-
nector and the heating pad are completely
3
dry. There is otherwise a risk of an electric shock.
DANGeR Of eLeCTRIC SHOCK!
DANGeR Of MATeRIAL
DAMAGe! Do not under any
circumstances switch the heating pad on to
help it dry.
Use a dry, non-fluffing cloth for cleaning and
care of the heating pad and control
You can dampen the cloth and use a little mild
liquid detergent to remove more stubborn dirt
from the heating pad.
DANGeR Of MATeRIAL
DAMAGe! Do not use chemical
cleaning or scouring agents to clean
the heating pad and control
pad may otherwise be damaged.
Never immerse the control
liquids. It may otherwise be damaged.
DANGeR
with
3
to
1
.
1
. The heating
1
in water or other
1
GB 9
19.05.11 13:16