Washing Guide - Fagor FET-7110A Waschanleitung

Detergent dispenser:
Prewash
Wash
Softener
Bleach
CORRECT WASHING PROCEDURE
Before using the washing machine, make sure that it has been installed correctly as reported
in the instruction book.
Daily use
1. Before placing the laundry in the washing machine, empty the pockets of any hard or sharp objects
(nails, screws, coins, pins, stones) which could damage the machine and ruin the clothing.
2. Open the top of the washing machine, lightly pressing downwards before lifting it.
3. Open the doors of the drum, pressing them lightly with one hand, while pressing the opening button
with the other.
4. To improve washing performance, load the laundry loosely without pressing on it, in order to avoid
overloading the machine. An entire load of particularly absorbing fabrics, such as sponge towels
and bathrobes, can unbalance the machine during the spin cycle. The automatic load-balancing
system places the laundry in the most homogeneous way possible and sets the optimal spin speed
to reduce vibrations to a minimum.
5. Close the drum doors making sure they are well hooked.
6. Dose the right amount of detergent in the appropriate chamber II. Add extra detergent in the chamber
I if you want to activate the prewash option. For softeners and bleaches, use the chamber marked
with the symbols
7. Select the washing program suitable for the type of fabrics using the I knob, following the instruc-
tions carried on the program table. One of the function bar LEDs will turn on to indicate the phase
with which the program will start. When the end LED turns on, the cycle is over.
8. Pressing C, it is possible to set a different spin speed from the one proposed by the selected pro-
gram. The B key allows postponing the start of the wash cycle up to a maximum of 8 hours. Both
values are indicated by the respective LEDs.
9. With the D, E, F and G buttons, supplementary functions can be selected. The options chosen are
indicated by their relative LEDs turning on. The duration of the wash cycle varies depending on
the options activated.
10. Press the H button to start the wash cycle. After a few seconds, the start LED will stay lit constantly,
indicating that the program has started.
11. The end of the wash cycle is indicated when the end LED turns on.
Place the I knob back to the stop position, open the top cover and the drum doors and take the
laundry out.
12. The program can be cancelled at any time by turning the I knob back to the stop position.
SM2978

WASHING GUIDE

Control panel:
A Wash Phases LEDS
B Delayed Start Button
C Spin button
D Prewash button
E Turbo button
and .
F Skin Care Button
G Easy Iron Button
H Start button
I Programme selector knob
S Spin Speed LEDS
T Delayed Start LEDS
3
EN