Final Assembly; Operation - HANSGROHE ibox M3 Montageanleitung

Attention! The fitting must be installed, flushed
and tested after the valid norms.
Assembly
Mount the body in such a way, that the outlet faces to
the top and that the marking on the protective cover
is flush with the face of the tiling.
Depth of fitting 55 - 83 mm.
Extension set 28 mm.
Note: When installation is complete ensure
that the mixer is turned off!
The pressures of the cold and hot water connections
must be balanced.

Final assembly

Finish set for Sportive
Finish set for Talis E
Finish set for Metropol
Finish set for Mondial
Finish set for Metris
Finish set for Focus E
Finish set for Talis S
Finish set for Metris E
Finish set for Metris S

Operation

The mixer is activated by pulling the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Connections G ½":
Rate of flow at 0,3 MPa:

English
32615000
33615000
14606XXX
15606XXX
31606000
31765XXX
32635000
31671000
31661000
max. 1 MPa
1,6 MPa
max. 80° C
65° C
cold right -
hot left
approx. 22 l/min
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled con-
tinuous flow heaters if the flow pressure is at least
0,15 MPa.
To adjust the hot water limiter on single lever mixers,
please see page 22.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts (see page 3)
1 nut
2 cartridge cpl.
3 seal
4 extension set 28 mm
95007000
92730000
95008000
32698000