Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SECURITY RECOMMENDATIONS AND WARNINGS
Assembly and connection
•
Have specialist personnel make the electrical connection of your device.
•
Have earth connection made in compliance with the standards. MANUFACTURER COMPANY is not
responsible for damages and failures which may arise from any improper practice.
•
Connection should not be made through an extension cable.
•
Do not use the device on the multi sockets.
•
Before connection is made, check whether there is any damage or not apparently. If there is any damage,
do not connect the device with the network.
•
Damages, which have occurred in the electrical cable or other parts, may be repaired and original part
support may be provided only by Combisteel BV or its authorized services.
•
Situations other than this are out of the responsibility.
•
WARNING: During the installation: Unless they are made from the incombustible material or they are
covered by heat insulated incombustible material, the device should not be placed onto the ground or
near the walls, partitions or kitchen furniture and similar objects and it should be paid attention to the
fire protection instructions.
Usage rules
•
Before starting to use your device, read the User Manual absolutely.
•
Use your device on a smooth surface.
•
Use your device in the room temperature.
•
Do not use your device other than its intended purpose; manufacturer company is not responsible for the
failures which may arise from the usages in the contrary case.
Protection of device from damage
•
Protect the parts of device such as power switch, socket, plug and engine etc. from the impacts.
•
Do not close the side gate quickly.
•
Due to the fact that resistances connected to the control board are the parts of hot region, unplug in order
to perform the cleaning process against fire hazard and clean after device becomes cold.
•
Do not use any water, vapor and similar pressurized cleaning materials. These materials damage the device.
They may cause work accidents by shorting out.
•
Never displace the device while it is hot.
In case of failure
•
When you determine any failure on the device, firstly switch off the fuse and unplug the device.
•
Do not make any electrical connection until repair process finishes.
•
All kinds of repair and maintenance transactions should be made by the Authorized Service. Contrary cases
may bring damage to you and device as well as MANUFACTURER COMPANY is not responsible for the
damages occurring.
Do not open and intervene in the body of device under any circumstances.
www.combisteel.com
5
Werbung
Inhaltsverzeichnis
