Inhaltsverzeichnis
Werbung
en
Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current
via a correctly installed earthed socket.
The socket must be fused with a 10 to
16 A fuse.
If the appliance is to be operated
in a non European country, check
on the rating plate whether the
indicated voltage and current type
correspond to the values of your
mains supply. The rating plate
is situated in the bottom left hand side
of the appliance. The mains
connection cable may be replaced by
an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs or to
power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
18
Switching on
the appliance
Fig. 2
Press main switch 1. The temperature
display light flashes until the required
temperature has been reached. Interior
light is switched on when the door
is open.
Selecting the
temperature
The set values can be changed; see
description of the fascia.
The factory has recommended and set
the following temperatures:
Refrigerator compartment
Perishable food should not be stored
warmer than +4 °C.
Notes:
Fig. 4
It is quite normal for condensation or
hoarfrost to form on the inside of the rear
panel. The hoarfrost thaws automatically
and runs into the evaporation pan via the
condensation channel.
Keep the condensation channel and
outlet clean, as the condensation must be
able to drain away.
+4 °C
Werbung
Inhaltsverzeichnis
