Olivetti Copia 9915F Druckerbedienungsanleitung Seite 10

INSTALLING THE PRINTER DRIVER SOFTWARE
Insert the installation CD-ROM into the CD-ROM drive.
5
Click the Start button and select Run. When the screen shown below appears, type
R:\SETUP (if the CD-ROM is designated as drive R) and click the OK button. Proceed
to step 7.
"Install from Disk" window will appear. Insert the installation CD-ROM into the CD-
6
ROM drive. Type R:\ (if the CD-ROM is designated as drive R) and click the OK button.
Proceed to step 7.
The installation program will start. To install the printer driver to the default folder, click
7
the Next button. To select a different folder, select Browse or type in the new path and
folder name. Click OK and say YES to create the folder, select the Next button to
continue.
On the display, you will see "printer port to be used". Normally, this is LPT1 and it is
8
selected automatically.
Ensure that Yes is checked to use the printer as the default printer.
Finally click the Next button.
A "Confirm installation" window will be displayed. To continue installation, click the Yes
9
button.
When the installation is complete, you will be asked whether or not to print a test page.
10
If you wish to do so, click the Yes button. At this time, ensure that paper is loaded in the
paper tray.
If the test print completes successfully, click the Finish button. "The installation of
11
the Copia 9915F Software is complete." window will be displayed. Click the OK
button.
If you have any problem with the test print, see TROUBLESHOOTING on
page 1-19 and check the symptoms and solutions. Print the test page again
after resolving the problem.
1-8