Olivetti Copia 9915D Druckerbedienungsanleitung Seite 24

STATUS MONITOR
Fault Messages
Message
TD cartridge is empty. Replace
empty TD cartridge with a new
cartridge.
Drum cartridge is at end of life.
Replace empty drum cartridge
with a new cartridge.
Front or Side Cover open.
Close Covers.
Insert TD cartridge into the
machine
Paper Jam
Check Paper Tray : Out of Paper
or Misfeed
Check Bypass Tray : Out of
Paper or Misfeed
Clear misfeed or load paper and
press "C" to continue.
Print Image Error
The print page may be incomplete.
Lower the print resolution and
reprint the job to fix the problem.
Service Error
Switch Main Power OFF on the
product. Wait approximately 5
seconds. Switch Main Power
ON. If the Service Error
continues, Contact your
authorized SHARP dealer.
OLIVETTI dealer.
Product Communication Error
The printer is either busy,
disconnected or off ; check the
printer. To cancel the job, press
the Cancel Job button.
The printer has an invalid TD
cartridge.
Remove cartridge and replace
with a valid TD cartridge.
*2: See the section on TD CARTRIDGE REPLACEMENT.
*3: See the section on DRUM CARTRIDGE REPLACEMENT.
*4: See the section on MISFEED REMOVAL.
*5: See the section on LOADING COPY PAPER.
*6: See the section on BYPASS FEED.
1-22
Description / Solution
The TD cartridge is empty. Printing cannot
continue until you replace the empty TD
cartridge with a new cartridge.
The drum cartridge is spent. Printing cannot
continue until you replace the spent drum
cartridge with a new cartridge.
One of the covers on the printer is open. Printing
cannot continue until you close the cover.
The TD cartridge is not in the printer. Insert a
TD cartridge into the printer.
A piece of paper has misfed within the printer.
Printing cannot continue until the misfed paper
is removed.
The paper tray is out of paper or the paper did not
feed correctly. Printing cannot continue until you load
the paper or clear the misfeed in the paper tray.
The bypass tray is out of paper or the paper
did not feed correctly. Printing cannot continue
until you load the paper or clear the misfeed in
the bypass tray.
The last page printed may be incomplete.
Possibly, the image is too complex.
Lower the print resolution to 300dpi and
reprint the job.
The printer has detected a fatal error condition
and cannot continue. Make a note of any
specific error conditions or codes. Then turn
the printer's power switch to OFF. Wait for five
seconds. Then turn the printer's power switch
to ON. If the error condition persists, please
contact your authorized SHARP dealer. OLIVETTI dealer.
The computer has lost communications with
the printer. Check all connections and power
switches, including at wall socket and on
printer. To cancel the job, press the Cancel
Job button.
The printer has an invalid TD cartridge. The
printer will not function until you remove
cartridge and replace with a valid TD cartridge.
See
page:
2
Copier*
3
Copier*
–
2
Copier*
4
Copier*
4
Copier*
5
Copier*
4
Copier*
6
Copier*
1-20
–
1-4,
1-5,
1-19
–