Introduction; Proper Use; Description Of Parts - Silvercrest B10 Bedienungsanleitung

Introduction

The following pictograms are used in these operating instructions or on the
electric overblanket:
Please read the operating instructions!
V ~
Volt (AC)
Hz
Hertz (frequency)
W
Watt (effective power)
Protection class II
Observe all warnings and safety
advice!
Keep children away from the electric
overblanket.
Electric Blanket
I ntroduction
Q
Please familiarise yourself with the heated
overblanket before using it for the first
time. Please read the following operating
instructions and the important safety instructions
carefully. Use the heated overblanket only as de-
scribed and for the stated areas of use. Keep this
manual in a safe place and always pass on all
documents together with the heated overblanket.

Proper use

Q
This heated overblanket is designed to warm the
human body. It must only be used as a cover, and
not as an underblanket. The heated overblanket is
not intended for use in hospitals or for commercial
6 GB
66899_silv_Waermezudecke_Content_LB4.indd 6
Risk of loss of life by electric shock from
damaged mains lead or mains plug!
Do not insert needles!
The textiles used in this electric over-
blanket meet the high human ecological
safety requirements of the Öko-Tex
Standard 100 as proven in tests at
the Hohenstein Research Institute.
Do not used if folded or drawn
together!
Caution – Risk of electric shock!
Risk to life!
The electric overblanket is machine-
washable. Set the washing machine
on a gentle 30 °C washing program.
Dispose of the packaging and the
electric overblanket in an environmen-
tally friendly manner.
use. In particular it must not be used for babies, infants,
persons who are insensitive to heat, helpless persons,
or animals. Any use other than that described above
or modification of the heated overblanket are not
permissible and may lead to injury and / or damage
to the heated overblanket. The manufacturer accepts
no liability for any damage caused by improper use.

Description of parts

Q
Control (see Fig. A)
1
Plug-in connector (see Fig. B)
2
15.07.11 09:21