Werbung
Introduction
Introduction
Figure 1
Back Panel of the Switch
CONSOL E
Using the Catalyst 2924M XL DC Ethernet Switch
6
The Catalyst 2924M XL DC switch is equipped with an on-board direct-current
(DC) power converter. The DC-power converter has dual feeds (A and B) that are
diode OR'd into a single power block.
The front panel of the switch provides 24 10/100 ports, 2 high-speed expansion
slots, a set of LEDs, and a Mode button. The rear panel of the switch (Figure 1)
provides an RJ-45 console port, a ground lug, and a DC power connector (also
referred to as the terminal block header). The switch is shipped with a terminal
block plug inserted in the DC power connector. For more information about the
front and rear panels of the switch, refer to the Catalyst 2900 Series XL
Installation Guide.
REFER TO MANUAL
BEFORE CONNEC TING
POWER
INPUT: 36 - 72
CURREN T: 4-2A
A
B
+ –
+ –
78-10499-01
Werbung
