Werbung
Wiring the DC-Input Power Source
Step 7
Insert the terminal block plug into the terminal block header on the rear panel of
the switch as shown in the figure.
Secure the wires coming from the terminal block so that they will not
Caution
be disturbed by casual contact. For example, use tie wraps to secure
the wires to a rack.
CONSOL E
Step 8
Remove the tape from the circuit-breaker switch handle, and restore power by
moving the circuit breaker handle to the on position.
Using the Catalyst 2924M XL DC Ethernet Switch
20
REFER TO MANUAL
BEFORE CONNEC TING
POWER
INPUT: 36 - 72
CURREN T: 4-2A
A
B
+ –
+ –
Tie wrap
78-10499-01
Werbung
