Werbung
Grounding the Switch
Grounding the Switch
Warning
Warning
Step 1
CONSOL E
Using the Catalyst 2924M XL DC Ethernet Switch
12
This equipment is intended to be grounded. Ensure that the host is
connected to earth ground during normal use.
When installing the unit, the ground connection must always be
made first and disconnected last.
Follow these steps to ground the switch to earth ground. Make sure to follow any
grounding requirements at your site.
Use a standard Phillips screwdriver or a ratcheting torque screwdriver with a
Phillips head to remove the two number-10-16 ground-lug screws and the ground
lug from the rear panel of the switch.
REFER TO MANUAL
BEFORE CONNEC TING
INPUT: 36 - 72
CURREN T: 4-2A
POWER
A
B
+ –
+ –
78-10499-01
Werbung
