Cisco Systems 2924M XL DC Handbuch Seite 13

Step 2 Set the screws and the ground lug aside.
If your ground wire is insulated, use a wire-stripping tool to strip the 6-gauge
Step 3
ground wire to 0.5 inch ± 0.05 inch as shown in this figure:
Step 4 Slide the open end of the ground lug over the exposed area of the 6-gauge wire.
Step 5 Using a Panduit crimping tool, crimp the ground lug to the 6-gauge wire.
78-10499-01
0.50" ± 0.05"
Insulation Wire lead
Using the Catalyst 2924M XL DC Ethernet Switch
Grounding the Switch
13