Installing The Imager Head Cable; Install Camera Accessories; To Install An Sd Card; Buttons, Controls, Ports - RIDGID microEXPLORER Bedienungsanleitung

microEXPLORER
3. Battery removal and installation.
A. To remove the battery pack, tilt unit
slightly to slide battery into other hand.
B. To install the battery, Insert contact
end of rechargeable battery pack into
the microEXPLORER inspection cam-
era, as shown in Figure 3 .
4. Replace battery cover (Figure 2) and
snap into place by sliding the lock button
to the middle and releasing to engage the
lock.
Installing the Imager Head
Cable
To use the microEXPLORER inspection cam-
era , the imager head cable must be con-
nected to the handheld display unit. To con-
nect the cable to the handheld display unit,
make sure the key and slot (Figure 4) are
properly aligned. Once they are aligned, finger
tighten the knurled knob to hold the con-
nection in place.
Slot
Figure 4 – Cable Connections
3' and 6' cable extensions are available to
increase the length of your cable up to 30' in
length. To install an extension, first remove the
camera head cable from the display unit by
loosening the knurled knob. Connect the ex-
tension to the handheld as described above
(Figure 4) . Connect the keyed end of the
camera head cable to the slotted end of the
extension and finger tighten the knurled knob
to hold the connection in place.
To Install Camera Accessories
The three included accessories, (mirror, hook
and magnet) (Figure 1) all attach to the imager
head the same way.
To connect, hold the imager head as shown in
Figure 5 . Slip the semicircle end of the ac-
cessory over the flats of the imager head as
shown in Figure 5 . Then rotate the accessory
a 1/4 turn so the long arm of the accessory is
extending out as shown (Figure 6) .
6
™ Digital Inspection Camera
Key
Ridge Tool Company
Imaging Head
Figure 5
Figure 6 – Installing Accessories

To install an SD Card

Using the tab on the port cover (Figure 7) , lift
and pull to remove the cover and expose the
SD card slot. Insert the SD card into the slot
making sure the contacts are facing towards
you and the angled portion of the card is facing
down. When an SD card is installed, a small
SD card icon will appear in the bottom right
hand portion of the screen, along with the
number of images or length of video that can
be stored on the SD card.
Buttons, Controls and Ports
Mini USB Port
Additional
Accessory
Ports
SD Card
Slot
ON/OFF
Button
Figure 7 – Port Cover
Accessory
Flats
Expansion
Bay Door
For Other
Accessories
(Sold Separately)
Port
Cover