Werbung
EMISSION CONTROL WARRANTY COVERAGE IS APPLICABLE TO CERTIFIED ENGINES PUR
CHASED IN CALIFORNIA IN 1995 AND THEREAFTER, WHICH ARE USED IN CALIFORNIA, AND
The California Air Resources Board (CARB), U.S. EPA and B&S are pleased to explain the Emission
Control System Warranty on your model year 2000 and later small off road engine (SORE). In Califor
nia, new small off road engines must be designed, built and equipped to meet the State's stringent anti
smog standards. Elsewhere in the United States, new non road, spark ignition engines certified for
model year 1997 and later, must meet similar standards set forth by the U.S. EPA. B&S must warrant
the emission control system on your engine for the periods of time listed below, provided there has been
Small off road engines are warranted relative to emission control parts defects for a period of two
years, subject to provisions set forth below. If any covered part on your engine is defective, the part
will be repaired or replaced by B&S.
As the small off road engine owner, you are responsible for the performance of the required mainte
nance listed in your Operating and Maintenance Instructions. B&S recommends that you retain all
your receipts covering maintenance on your small off road engine, but B&S cannot deny warranty
solely for the lack of receipts or for your failure to ensure the performance of all scheduled mainte
nance.
As the small off road engine owner, you should however be aware that B&S may deny you warranty
coverage if your small off road engine or a part has failed due to abuse, neglect, improper mainte
nance or unapproved modifications.
The following are specific provisions relative to your Emission Control Defects Warranty Coverage. It is in addition to the B&S engine warranty for non regulated engines found in the Operating and Maintenance Instructions.
1. Warranted Parts
Coverage under this warranty extends only to the parts listed below (the emission control
systems parts) to the extent these parts were present on the engine purchased.
a. Fuel Metering System
• Cold start enrichment system (soft choke)
• Carburetor and internal parts
• Fuel Pump
b. Air Induction System
• Air cleaner
• Intake manifold
c. Ignition System
• Spark plug(s)
• Magneto ignition system
d. Catalyst System
• Catalytic converter
• Exhaust manifold
• Air injection system or pulse valve
e. Miscellaneous Items Used in Above Systems
• Vacuum, temperature, position, time sensitive valves and switches
• Connectors and assemblies
After July 1, 2000, Look For Emissions Compliance Period On Engine Emissions Compliance Label
After July 1, 2000 certain Briggs & Stratton engines will be certified to meet the United Sattes Environmental Protecteion Agency (USEPA) Phase 2 emission standards. For Phase 2 certified engines, the
Emissions Compliance Period referred to on the Emissions Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. For engines
less than 225 cc displacement, Category C = 125 hours, B = 250 hours and A = 500 hours. For engines of 225 cc or more, Category C = 250 hours, B = 500 hours and A = 1000 hours.
The displacement of Model Series 190000 engines is 319 cc. The displacement of Model Series 280000 engines is 465 cc.
This is a generic representation
of the emission label typically
found on a certified engine.
(This page applicable in the U.S.A and Canada only.)
Briggs & Stratton Corporation (B&S), the California Air Resources Board (CARB)
and the United States Environmental Protection Agency (U.S. EPA)
Emission Control System Warranty Statement (Owner's Defect Warranty Rights and Obligations)
California, United States and Canada Emission Control Defects Warranty Statement
Briggs & Stratton Emission Control Defects Warranty Coverage
Owner's Warranty Responsibilities
Briggs & Stratton Emission Control Defects Warranty Provisions
TO CERTIFIED MODEL YEAR 1997 AND LATER ENGINES WHICH ARE PURCHASED AND USED
ELSEWHERE IN THE UNITED STATES (AND AFTER jANUARY 1, 2001 IN CANADA).
no abuse, neglect or improper maintenance of your small off road engine.
Your emission control system includes parts such as the carburetor, air cleaner, ignition system,
muffler and catalytic converter. Also included may be connectors and other emission related as
semblies.
Where a warrantable condition exists, B&S will repair your small off road engine at no cost to you
including diagnosis, parts and labor.
You are responsible for presenting your small off road engine to an Authorized B&S Service Dealer
as soon as a problem exists. The undisputed warranty repairs should be completed in a reasonable
amount of time, not to exceed 30 days.
If you have any questions regarding your warranty rights and responsibilities, you should contact a
B&S Service Representative at 1 414 259 5262.
The emission warranty is a defects warranty. Defects are judged on normal engine performance.
The warranty is not related to an in use emission test.
2. Length of Coverage
B&S warrants to the initial owner and each subsequent purchaser that the Warranted Parts
shall be free from defects in materials and workmanship which caused the failure of the War
ranted Parts for a period of two years from the date the engine is delivered to a retail purchaser.
3. No Charge
Repair or replacement of any Warranted Part will be performed at no charge to the owner, in
cluding diagnostic labor which leads to the determination that a Warranted Part is defective, if
the diagnostic work is performed at an Authorized B&S Service Dealer. For emissions warranty
service contact your nearest Authorized B&S Service Dealer as listed in the Yellow Pages"
under Engines, Gasoline," Gasoline Engines," Lawn Mowers," or similar category.
4. Claims and Coverage Exclusions
Warranty claims shall be filed in accordance with the provisions of the B&S Engine Warranty
Policy. Warranty coverage shall be excluded for failures of Warranted Parts which are not origi
nal B&S parts or because of abuse, neglect or improper maintenance as set forth in the B&S
Engine Warranty Policy. B&S is not liable to cover failures of Warranted Parts caused by the
use of add on, non original, or modified parts.
5. Maintenance
Any Warranted Part which is not scheduled for replacement as required maintenance or which
is scheduled only for regular inspection to the effect of repair or replace as necessary" shall be
warranted as to defects for the warranty period. Any Warranted Part which is scheduled for
replacement as required maintenance shall be warranted as to defects only for the period of
time up to the first scheduled replacement for that part. Any replacement part that is equivalent
in performance and durability may be used in the performance of any maintenance or repairs.
The owner is responsible for the performance of all required maintenance, as defined in the
B&S Operating and Maintenance Instructions.
6. Consequential Coverage
Coverage hereunder shall extend to the failure of any engine components caused by the failure
of any Warranted Part still under warranty.
Werbung
