Configuration; Process Value Input - JUMO iTRON 04 B Betriebsanleitung

5

Configuration

H
Time-out If no key is pressed for 30 seconds, the controller will automatically return to the temperature
display.
Parameters Individual parameters will not be visible if they have been disabled in the parameter ring
through the setup program (accessory).
h
Change over to the parameter level using

Process value input

Parameter Meaning
SEn Transducer
connected transducer
uni Unit
for the indicated temperature and parameters with temperature unit
OFF Process value correction
temperature offset in °C or °F
dF Filter time constant
to adapt the digital input filter (
At a signal step, 63% of the signal change has been registered
after the set time has elapsed.
If the filter time constant is large:
- high damping of interference signals
- slow reaction of the process value display to changes in process value
+ (hold both down for 5 seconds!)
dF
=0.0 switches the filter off).
Value range
from ... factory-set ... to
001 (Pt100)
040 (thermocouple J)
042 (thermocouple L)
043 (thermocouple K)
°C or °F
-99 ... 0 ... +999
0.0 ... 1.0 ... 99.9s
11