VESTEL VEA 36016 Bedienungsanleitung Seite 113

appropriate electronic button. Each button
pressed is followed by a buzzer sound.
Switching the Hob On
Switch the hob on by pressing the ON/OFF
button . All heater displays will show a
static "0" and the bottom right dots blink.
(If a cooking zone is not selected within 20
seconds, the hob will automatically switch
off).
Switching the Hob Off
Switch the hob off at any time by pressing
.
The ON/OFF button
over the switch-off function.
Switching the Cooking Zones On
Press the heater selection button that
corresponds to the heater you wish to use.
A static dot will be shown on the selected
heater display and the blinking dots on
all other heater displays will no longer
illuminate.
Select the temperature setting by using the
increase heat setting button
heat setting button
ready to use. For faster boil times, select
the desired cooking level, then touch the 'P'
button to activate the Boost function.
Switching the Cooking Zones Off
Select the element you want to switch off by
pressing the heater selection button. Using
the button, turn the temperature down
to "0". (Pressing the
simultaneously also turns the temperature
to "0").
If the cooking zone is hot, "H" will be
displayed instead of "0".
Switching all Cooking Zones Off
To switch all the cooking zones off at once,
press the key.
In the stand-by mode, a "H" will appear on
all cooking zones which are hot.
Residual Heat Indicator
The residual heat indicator indicates that
the glass ceramic area has a temperature
that is dangerous to touch.
After switching off the cooking zone, the
respective display will show "H" until the
corresponding cooking zone temperature is
at a safe level.
Bridge Zone
Switching the Bridge Zone On
Press the front left and rear left heater
selection buttons simultaneously. A static
always has priority
or decrease
. The element is now
and buttons
dot will be shown on the left heater display.
The other displays will show 'b' and 'r' and
the blinking dots will no longer be displayed.
Select the temperature required by using
the increase heat setting button
decrease heat setting button
bridge element will be ready to use. For the
fastest boil time, select the desired cooking
level, then press the "P" key to activate the
Boost function.
Switching the Bridge Zone Off
To select the Bridge element, press the rear
left or front left heater selection button and
using the
"0". Alternatively, pressing the
keys simultaneously will change the level
to "0".
If the bridge cooking zone is hot, "H" will be
displayed .
Smart Pause
Smart Pause, when activated, reduces
the power of all burners that have been
switched on.
If you then deactivate the Smart Pause,
the heaters will automatically return to the
previous temperature level.
If the Smart Pause is not de-activated, the
cooktop will switch off after 30 minutes.
Press to activate Smart Pause. The
power for the activated heater(s) will reduce
to level 1 and "II" will appear at all displays.
Press again to deactivate Smart
Pause. "II" will disappear and the heaters
will now run at the level previously set.
Safety Switch-Off Function
A cooking zone will automatically switch off
if the heat setting has not been modified
for a specified duration of time. A change
in the heat setting of the cooking zone will
reset the time duration to the initial value.
This initial value depends on the selected
temperature level, as shown below.
Heat setting
1-2
3-4
5
6-9
Child Lock
After switching on the appliance, the child
lock function can be activated. To activate
the child lock, simultaneously press the
increase heat setting button
EN - 22
button, turn the level down to
Safety switch off after
6 Hours
5 Hours
4 Hours
1.5 Hours
and
or
. The
and