Connecting The Appliance; Switching On The Appliance; Operating Tips; Selecting The Temperature - Bosch KTW serie Gebrauchs- Und Montageanleitung

Connecting
the appliance
After installing the appliance, wait at
least 1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for
the first time, clean the interior of the
appliance (see chapter Cleaning).
The socket must be close to the
appliance and must be freely accessible
even after the appliance has been
installed.
Connect the appliance only to
220 – 240 V/50 Hz alternating current
via a correctly installed earthed socket.
The socket must be fused with a 10 A
to 16 A fuse.
If the appliance is to be operated in
a non‐European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the bottom
left‐hand side of the appliance.
The power cord may be replaced by
a technician only.
!
Warning
Never connect the appliance to
electronic energy saver plugs or to
power inverters which convert the direct
current to 230 V alternating current (e.g.
solar equipment, power supplies on
ships).
Switching on the
appliance
Press the On/Off button Fig. !/1.
The appliance starts refrigerating.
Interior light is switched on when the
door is open.
At the factory the appliance has been
set to the middle setting 3.

Operating tips

While the refrigerating unit is running,
beads of water or hoarfrost form at the
back of the refrigerator compartment.
This is quite normal. It is not necessary
to scrape off the frost or wipe off the
beads of water. The rear panel defrosts
automatically. The condensation collects
in the drainage channel Fig. $ and is
conveyed to the refrigerating unit where
it evaporates.
Selecting the
temperature
The temperature can be set from 1 - 5.
Press selection button Fig. !/6 for
3 seconds until display flashes. Then
keep pressing the selection button until
the required setting is displayed.
The last setting is saved.
Setting 1, low cooling capacity.
Setting 5, maximum cooling capacity
At a setting of 3 a refrigerator
compartment temperature of +8 °C to
+12 °C is reached depending on the
ambient temperature and load.
en
21