en
Installing the appliance
Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e.g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use
a suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to electric or gas cookers.
30 cm to an oil or solid‐fuel cooker.
Changing over the door hinges
The door hinges on this appliance
cannot be changed over.
Aligning the appliance
Fig. "
Place the appliance in the designated
location and align.
The front screw feet can be adjusted.
20
Note ambient
temperature and
ventilation
The climatic class can be found on the
rating plate. It specifies the ambient
temperatures at which the appliance
may be operated.
Climatic category
N
ST
T
!
Attention
The room temperature must not drop
below +16 °C.
Otherwise the refrigerator compartment
will become too cold and perishable
items may be damaged.
Ventilation
Fig. #
The heated air on the side panels of the
appliance must be able to escape freely.
Otherwise, the refrigerating unit must
work harder and the power consumption
is increased.
For this appliance there must be a 4 cm
gap between the wall and adjacent fur
niture.
This distance is also required so that the
door can be opened by at least 90°.
Permitted ambient
temperature
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C