EuroLite LED TMH-S30 Bedienungsanleitung Seite 24

Main menu
Addr
CHnd
SLnd
SHnd
Soud
SEnS
blnd
LEd
dISP
rPAn
rTIL
Reset
TEMP
Addr / DMX address setting
With this function, you can adjust the desired DMX address via the Control Board.
CHnd / DMX channel mode
With this function, you can select the desired DMX channel mode.
SLnd / Master / Slave setting
With this function, you can define the device as master or slave. You can choose one of two different Slave
programs.
SL 1 = Synchronous movement, SL 2 = Asynchronous movement
SHnd / auto program
Auto mode (SH0 – SH3)
With this function, you can run 4 different internal programs.
Soud / music control
With this function, you can run the internal program sound-controlled.
SEnS / Mic sensitivity
With this function, you can select the desired microphone sensitivity between 0 % and 100 %.
blnd / no DMX status
With this function, you can set different modes if there is no DMX-signal.
LEd / Display turn off
With this function, you can shut off the display: ON the display stays lit; OFF the display turns off after 10
seconds.
dISP / display reverse
With this function, you can flip the display by 180° for a better view when the fixture is hung from a truss or a
ceiling.
rPAN / Invert PAN
With this function, you can reverse the PAN-movement.
rTIL / Invert TILT
With this function, you can reverse the TILT-movement.
rESt / Reset
With this function you can reset the device via the Control Board.
Sub menu
A001 ~ A512
10 CH/ 12 CH
MAST/SL 1/SL 2
SH0/SH1/SH2/SH3
On/oFF
0 - 100
blAC/Auto/Soun/HoLd
OFF/ON
No/Yes
No/Yes
No/Yes
No/Yes
Function
DMX address setting
DMX channel mode
Master/Slave setting
Auto program SH0 – SH3
Music control
Mic sensitivity
Run if no DMX
Display turn off
Display reverse 180 degree
Reverse movement
Reset
Shows the current fixture temperature
24/28 127079.docx, Version 1.0