Installation - EuroLite LED TMH-S30 Bedienungsanleitung

INSTALLATION

WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
(1) Omega-holders
(2) Clamp
(3) Safety bond
(4) Quick-lock fastener
The device may be placed on the floor or fastened to a truss or similar rigging structure. The device must
never be fixed swinging freely in the room.
1 The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2 Block access below the work area and work from a stable platform when installing the device.
3 Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware and follow the
instructions mentioned at the bottom of the base. Screw one clamp via a M10 screw and self-locking nut
onto the Omega-holder. Insert the two quick-lock fasteners of the Omega-holder into the respective holes
on the bottom of the device. Tighten the quick-lock fasteners fully clockwise.
4 Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. For the
attachment of a safety bond, the supplied eyelet must first be mounted on the device. Install the safety
bond by inserting the quick link in the eyelet on the bottom of the base. Pull the safety bond over the
trussing system etc. Insert the end in the quick link and tighten the fixation screw. Fasten the safety bond
in such a way that, in the event of a fall, the maximum drop distance of the device will not exceed 20 cm.
5 Make sure that the Omega-holder is always in line with the truss structure when installing the device
vertically.
6 After installation, the device requires inspections periodically to prevent the possibility of rot, deformation
and looseness.
4
20/28
3
2
127079.docx, Version 1.0
1