Note:
• If you are unsure about the measured amperage range, set the function
switch to a higher range.
• If the LCD shows „1" , it means a really high value, and the range should
be set to a higher value.
• Max. input amperage 200 mA or 10 A (depends on where the red
measuring wire is connected to), in case of high amperage the fuse
melts.
A~ measuring
• Connect the black measurning wire to the „COM" socket and the red one to
the „mA" socket (max. 200 mA) or connect the red one to the „10 A" socket
(max. 10 A).
• Set the function switch to the proper „A~" setting and connect the wires to the
circuit.
Note:
• If you are unsure about the measured amperage range, set the function
switch to a higher range
• If the LCD shows „1" , it means a really high value, and the range should
be set to a higher value.
• Max. input amperage 200 mA or 10 A (depends on where the red
measuring wire is connected to), in case of high amperage the fuse
melts.
Resistance measurement
• Connect the black measurning wire to the „COM" socket and the red one to
the „V/Ω" socket.
• Set the function switch to the proper resistance setting and connect the wires
to the resistance you wish to measure.
Note:
• If the value of the measured resistance is higher than the choosen
maximum value, the LCD shows „1", and the function switch has to set to
a higher setting value. If the resistance is above 1 MΩ, the device needs
some seconds to stabilise.
Diode and continuity test
• Connect the black measurning wire to the „COM" socket and the red one to the
„V/Ω" socket. (Note: the polarity of the red wire: „+")
• Set the function switch to „
you wish to measure
• Connect the wires to the 2 points of the part, if the device beeps the resistance
is lower than approx. (30±20)Ω
Background lighting
• Push the button '10' long to turn on or off the background lighting.
" setting and connect the wires to the diode