Central Intake Fans/Radiator; Rear Exhaust Fan/Radiator - Antec Signature serie Benutzerhandbuch

4.2 Central Intake Fans / Radiator – Motherboard Chamber
There are 3 x 120 mm fans preinstalled on the front of the Motherboard Chamber. These fans are perpendicular to
the VGA cards and constantly supply cool air quietly and efficiently to the cards from the Central Air Intake.
1. Open the side panel. The fan bracket is held by two thumbscrews at the front of the chamber (figure 34).
2. Loosen the thumbscrews to remove the fan bracket from the upper housing (figure 35).
Note: Disconnect the fan power connector before removing the fan bracket.
3. You can service the fans as you wish now.
Note: This bracket is also compatible with 3 x 140 mm fans.
4. Reinstall the fan bracket back to the location. Make sure to align the three tabs with the holes inside the
case and reinstall the thumbscrews.
For 360 mm / 280 mm / 240 mm Radiator Installation:
This bracket is compatible with 360 mm, 280 mm or 240 mm radiator for water cooling. Follow the original
instructions from the water cooling system to install the radiator to the fan bracket.
Figure 34
Speed Start Voltage
900 RPM
4.3 Rear Exhaust Fan / Radiator – Motherboard Chamber
Figure 37
Speed Start Voltage
900 RPM
rev 1C
Input Current
7V 0.12A (Max)
The included 120 mm fan on the rear of the Motherboard Chamber cools your
CPU quietly and efficiently. This mounting is also compatible with a 120 mm
radiator, should you choose to install one.
120 mm fan specifications
Rated Voltage:
Operating Voltage:
Input Current
7V 0.12A (Max)
Figure 35
Air Flow Static Pressure
0.54mm-H O
2
39.5 CFM
(0.021 inch-H O)
2
DC 12V
7.0V-13.2V
Air Flow Static Pressure
0.54mm-H O
2
39.5 CFM
(0.021 inch-H O)
2
Figure 36
Acoustic
Input Power
Noise
14.7 dBA 1.44 W (max)
Acoustic
Input Power
Noise
14.7 dBA 1.44 W (max)
S10 User Manual 19