DeWalt DPN1564A-XJ Originalanweisungen Seite 9

Operating instructions
LOADING THE TOOL
m Warning: When loading the tool 1) Never place a hand or
any part of the body in fastener discharge area of the tool; 2)
Never point the tool at self or anyone else; 3) Do not pull the
trigger or depress the safety yoke as accidental actuation
may occur, possibly causing injury.
DPN1850-XJ / DPSB2IN1-XJ
1. Depress magazine release button and pull back
magazine. (Fig. 1)
2. With magazine fully open, insert fasteners. Points must be
against bottom of magazine. (Fig. 2)
3. Push magazine forward. Continue pushing until latch is
engaged. (Fig. 3)
DPSSX38-XJ / DPSSL540-XJ
1. Depress magazine release button and pull back
magazine. (Fig. 4)
2. Open magazine fully. Turn tool sideways with discharge
area pointed away from yourself & others. Load staples in
channel. (Fig. 5)
3. Push magazine forward. Continue pushing until latch is
engaged. (Fig. 6)
DPN1564A-XJ, DPN1664-XJ
These nailers are equipped with dual load purpose
magazines. Nails can be loaded in either method.
LOAD AND PULL PUSHER
1. Load nails through the slot in the rear of the magazine
and past retaining clip. (Fig. 7)
2. Pull pusher back behind nail stick and release. (Fig. 8)
3. Ensure magazine pusher is behind the last nail
stick. (Fig. 9)
PULL PUSHER TO LOCK BACK AND LOAD
1. Pull pusher back until it is locked at the end of magazine.
(Fig. 10)
2. Load nails through the slot in the rear of the magazine
and past retaining clip. (Fig. 11)
3. Press the pusher button to release and allow the pusher
to push behind the nails. (Fig. 12)
4. Blow the magazine clean periodically to keep the pusher
moving smoothly and to keep dirt and debris out of the
nail channel.
JAM CLEARANCE
m Warning! Always disconnect the air before clearing a
jammed fastener.
Jam Clearing
1. Disconnect the air supply from the tool.
2. Relieve fasteners from pusher or open the magazine.
3. Open the jam clearing nose door by pulling down and
then up on the latch (Fig. 13).
4. Remove the jammed fastener. In certain circumstances,
pliers may be required to remove the fastener.
5. Close the jam clearing nose door latch (Fig. 14).
6. Pull pusher back behind fasteners or close the magazine.
FASTENER CONTROL ADJUSTMENT (FIG. 15)
The DIAL-A-DEPTH™ Fastener Control adjustment feature
provides close control of the fastener drive depth; from flush
with the work surface to shallow or deep countersink.
First, set the air pressure for consistent drive in the specific
work, then use the DIAL-A-DEPTH™ Fastener Control
adjustment to give the desired depth of drive.
TRIGGER LOCKOUT CONTROL (FIG. 16)
(DPN1564A-XJ, DPN1664-XJ)
The trigger lockout control feature on DEWALT pneumatic
tools provides a trigger lock feature for added safety control.
Push the Lockout control button in or out to activate or lock
the tool trigger.
UTILITY HOOK
These tools may include an additional utility hook suitable for
storage and temporary hanging of the tool.
m WARNING! Never use the utility hook to hang the tool
from the body, clothing or belt.
m WARNING! Never use the utility hook with contact (black)
trigger operated tools.
ENGLIS H
9