Required Assembly Material - FLORABEST FGW 84 A1 Montage- Und Bedienungsanleitung

Assembly

Required assembly material

IMPORTANT
► To avoid possible injury, the screw heads should always face outwards.
First tighten all screw connections down when the assembly is complete,
this will help avoid undesirable material tensions.
Step 1
♦ Connect the storage holder
washers Ø 5.4, M5 x 10 screws and nuts M5.
Please take note that only the lower hole of the storage holder
used for the screws.
♦ Secure the reinforcing braces
the washers Ø 5.4, M5 x 10 screws and nuts M5. Secure the reinforcing
braces
M5 x 10 screws and nuts M5.
♦ Assemble the wheel braces
to the left of the fi re bowl
screws and nuts M5. For this, use the upper hole in the wheel braces
15
14
FGW 84 A1
Hammer
Philips-type screwdriver
Open-ended spanners SW 8 mm, SW 13 mm
15
16
with the storage holders
16
14
by means of the washers Ø 5.4, 2 M5x12
6
15
with the wheel brace
14
with the wheel braces
by means of the washers Ø 5.4,
15
, with the assembled storage holder
14
16
by means of the
is to be
15
by means of
14
,
15
.
14
6
5
GB