Simons Voss Technologies CompactReader Kurzanleitung Seite 33

CompactReader
4. Remove the cover with the electronics (not clipped in at the fact-
5. Pull off the protective foil of the adhesive surfaces.
NOTE
Weakened adhesive surface due to contamination
The bond is weakened by grease or dust.
1. Clean the surface on which you want to mount the CompactReader
2. Do not touch the glued surfaces.
6. Only place the upper edge of the lower shell in the marked position
EN
ory).
before gluing.
so that the TOP mark points upwards.
6. Installation
33 / 136