Hendi 222157 Bedienungsanleitung Seite 7

• Once connected to the power plug, "3" will be
shown on the LCD display (4).
• Lower the blending part (7) into the food contain-
er (not supplied). Fully submerge blade (8) into
the ingredients before starting the appliance.
ATTENTION: You should not submerge the blend-
ing part (7) above the Max. mark.
• Hold the main unit (10) firmly with one hand and
the mixing container with the other hand.
• Press and hold the ON / OFF button (1), the appli-
ance then starts blending continuously.
• Use a gentle up-and-down motion to blend the
food ingredients smoothly.
• To avoid food spattering, do not lift the appliance
out of the ingredients during operation.
• Select the blade speed by pressing the + (2) or
- (3) button (Speed range: 1 to 6) during opera-
tion. The blade speed will be shown on the LCD
display (4).
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before
cleaning and disassembly the blending part (7).
Cleaning
• Remove all obstacles near the blade.
• Place the blending arm and the bell in a suitable
container with clean water and switch on for a
few seconds. Never immerse the shaft above the
Max. mark.
Recommended cleaning procedure:
Parts
Main unit with motor
(10)
Blending part (7)
Blade (8)
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electrical
outlet and cooled down completely.
How to clean
• Never immerse this part into water or other liquids.
• Using a damp cloth with some detergent and water, rinse, sanitize and
dry thoroughly.
• Clean it with warm water and some mild detergent. Do not submerge
the Detachable blending part (7) above the Max. mark.
• Dry all parts before using again.
• Warning! Risk of injury! Take great care when cleaning the blades.
• Clean it with warm water and some mild detergent.
• Dry it thoroughly after cleaning.
Note: No need to press the ON/OFF button (1) when
selecting the blade speed simultaneously.
• After finish operation, release the ON / OFF but-
ton (1) to switch off the appliance.
• Wait until the blade (8) stop completely. Then, un-
plug it from the electrical supply.
• Turn the main unit (10) clockwise to disassembly
the blending part (7) for cleaning.
Note:
1. Press and hold the decreasing and increasing
button + (2) or - (3) button for fast adjustment.
2. The default blade speed will be set to "3" once
plug in.
• Never immerse the motor unit or the handle in
water; clean with a damp cloth or a sponge.
WARNING: Always dry the blades thoroughly after
cleaning to avoid rust spotting.
• Store the appliance in a cool, clean and dry place
and keep out of reach of the children.
EN
Frequency
Clean after each
use
7